PGH20SW J1000 8627641 Walterscheid® Walterscheid® Safety guard half inner PGH 20 - 1116500

Walterscheid® Safety guard half inner PGH 20 - 1116500

Product number: 1116500

PGH20SW J1000 8627641


Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.


Inner safety guard half for PowerDrive drive shaft

Product advantages

The PowerDrive driveshaft with single joints can be combined with a full guard. It eliminates the need for the guard pot on the equipment side and both retaining chains, and the dangerous rotation of the complete guard is prevented. For easy handling of the PowerDrive PTO shaft, the guard funnels can be easily unlocked and pushed back. The resulting free space makes it much easier to connect and disconnect the PTO shafts and to maintain the joints and guard bearings.
The scope of delivery includes a complete Walterscheid protective half consisting of 1x protective tube half, 1x protection funnel, 1x sliding ring PG20, 1x sliding ring PG25 adapter and 6x screw.
Type
PGH
Size
20
Manufacturer
Walterscheid
J/A
J
Rohrlänge
1000.00
Schutzgröße
20
Trichtertyp
VT
Trichter-SNR
120603
Protective colour
SCHWARZ
KPL/TKPL
KPL
Drawing
86.231
Guard type
PGH
ass: 0 sim: 0 croo: 0
Comer Industries Corporation Logo

© 2026 - Walterscheid Productfinder – v4.8.2b   | Walterscheid GmbH | Walterscheid GmbH | We reserve the right to make design changes. Only use products for the intended purpose. We only accept responsibility for consistent quality. Reprints whether in whole or in part are only allowed with the written permission of Walterscheid GmbH.

Notify me when available

You will be notified as soon as the article is available again.