Walterscheid® Safety guard half outer STH 25 - 1113792

Product number: 1113792

STH25 A1500 8526114


Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.


Outer safety guard half for standard drive shaft size W2300 | W2400 | W2500

Product advantages

The advantage of profiled guards is that the two halves of the guard are rotationally fixed. As a result, at least one retaining chain on the PTO drive shaft guard (preferably on the tractor side) is no longer needed. The risk of guard defects due to incorrect chain attachment is reduced. In combination with a full guard on the implement side, it is even possible to dispense with both retaining chains. This is a real plus when it comes to safety, since a defective guard cannot provide adequate protection against the rotating PTO drive shaft.
The scope of delivery includes a complete Walterscheid protective half consisting of 1x protective tube half, 1x protective funnel, 1x SD support ring, 1x sliding ring and 1x screw for protective funnel.
Size
STH25
L [mm]
1500
J/A
A
Trichtertyp
RP14
n1)
14
Trichter-SNR
626114
KPL/TKPL
KPL
Protective colour
GELB
D [mm]
173
Rohrlänge
1500.00
Schutzgröße
25
Guard type
STH

ass: 4 sim: 0 croo: 0